Enterasys Matrix DFE-Gold Series Configuration Manual page 842

Configuring 802.1X Authentication
Mode
Switch command, Read‐Only.
Examples
This example shows how to display 802.1X status:
Matrix(rw)->show dot1x
DOT1X is disabled.
This example shows how to display authentication diagnostics information for fe.1.1:
Matrix(rw)->show dot1x auth-diag fe.1.1
Port: 1
Enter Connecting:
EAP Logoffs While Connecting:
Enter Authenticating:
Success While Authenticating:
Timeouts While Authenticating:
Fail While Authenticating:
ReAuths While Authenticating:
EAP Starts While Authenticating:
EAP Logoff While Authenticating:
ReAuths While Authenticated:
EAP Starts While Authenticated:
EAP Logoff While Authenticated:
Backend Responses:
Backend Access Challenges:
Backend Other Requests To Supp:
Backend NonNak Responses From Supp:
Backend Auth Successes:
Backend Auth Fails:
This example shows how to display authentication session statistics for fe.1.1:
Matrix(rw)->show dot1x auth-session-stats fe.1.1
Port: 1
Session Octets Rx:
Session Octets Tx:
Session Frames Rx:
Session Frames Tx:
Session Id:
Session Authentic Method: Remote Auth Server
Session Time:
Session Terminate Cause:
Session UserName:
This example shows how to display authentication statistics for fe.1.1:
25-4 Authentication Configuration
Auth-Diag:
Auth-Session-Stats:
0
0
0
0
(1, 00-00-00-00-00-00)
0 secs
Port Failure
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
show dot1x