Show Authentication Login; Set Authentication Login - Enterasys Matrix DFE-Gold Series Configuration Manual

show authentication login

For information about...
show authentication login

set authentication login

clear authentication login
show authentication login
Use this command to display the current authentication login method.
Syntax
show authentication login
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the current authentication login method:
Matrix(rw)->show authentication login
Current authentication login is any
set authentication login
Use this command to set the authentication login method.
Syntax
set authentication login {any | local | radius | tacacs}
Parameters
any
local
radius
tacacs
Specifies that the authentication protocol will be selected using the
following precedence order:
• TACACS+
• RADIUS
• Local
Specifies that the local network password settings will be used for
authentication login.
Specifies that RADIUS will be used for authentication login.
Specifies that TACACS+ will be used for authentication login.
Enterasys Matrix DFE-Gold Series Configuration Guide 25-51
Setting the Authentication Login Method
Refer to page...
25-51
25-51
25-52