Clear Spantree Lp; Show Spantree Lplock - Enterasys Matrix DFE-Gold Series Configuration Manual

clear spantree lp

If no SID is specified, SID 0 is assumed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display Loop Protect status on fe.2.3:
Matrix(rw)->show spantree lp port fe.2.3
LoopProtect is enabled on port fe.2.3
clear spantree lp
Use this command to return the Loop Protect status per port and optionally, per SID, to its default
state of disabled.
Syntax
clear spantree lp
Parameters
port‐string
sid sid
Defaults
If no SID is specified, SID 0 is assumed.
Mode
Switch command, Read‐Write.
Example
This example shows how to return the Loop Protect state on fe.2.3 to disabled:
Matrix(rw)->clear spantree lp port fe.2.3

show spantree lplock

Use this command to display the Loop Protect lock status per port and/or per SID.
Syntax
show spantree lplock [port port-string] [sid sid]
port-string [sid sid]
Specifies port(s) for which to clear the Loop Protect feature status. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
(Optional) Specifies the specific Spanning Tree(s) for which to clear the
Loop Protect feature status. Valid values are 0 ‐ 4094. If not specified,
SID 0 is assumed.
Configuring Spanning Tree Loop Protect Features
, SID 0
Enterasys Matrix DFE-Gold Series Configuration Guide 6-67