Set Next Hop; Show Ip Policy - Enterasys Matrix DFE-Gold Series Configuration Manual

set next hop

set next hop
Use this command to set one or more next hop IP address for packets matching an extended access
list in a configured route map.
Syntax
set next hop {next-hop1}[next-hop2....next-hop5]
no set next hop {next-hop1}[next-hop2....next-hop5]
Parameters
next‐hop
Defaults
None.
Mode
Router command, Policy‐based routing configuration: Matrix>Router(config‐route‐map‐pbr)#
Usage
The "no" form of this command deletes next hop IP address(es).
Example
This example shows how to set IP address 10.2.3.4 as the next hop for packets matching ACL 1:
Matrix>Router(config)#route-map 101 permit 20
Matrix>Router(config-route-map-pbr)#match ip address 1
Matrix>Router(config-route-map-pbr)#set next-hop 10.2.3.4

show ip policy

Use this command to display the policy applied to a routing interface.
Syntax
show ip policy
Parameters
None.
Defaults
None.
Mode
Router command, Global configuration: Matrix>Router(config)#
Specifies a next hop IP address(es). Up to five can be configured.
Enterasys Matrix DFE-Gold Series Configuration Guide 8-45
Configuring Policy-Based Routing