Show Interface; Purpose; Commands; Vlan And Loopback Interface Configuration Modes - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Routing Interface Settings
Table 16-1 VLAN and Loopback Interface Configuration Modes
For Routing
Interface Type...
VLAN
Loopback
Local (software
loopback)
For details on how to enable all router CLI configuration modes, refer back to Table
For details on configuring routing protocols, refer to Chapter

Purpose

To enable routing interface configuration mode on the device, to create VLAN or loopback routing
interfaces, to review the usability status of interfaces configured for IP, to set IP addresses for
interfaces, and to enable interfaces for IP routing at device startup.

Commands

For information about...

show interface

interface
ip ecm-forwarding-algorithm
show ip interface
ip address
no shutdown
show interface
Use this command to display information about one or more interfaces (VLANs or loopbacks)
configured on the router.
Syntax
show interface [vlan vlan-id | loopback loopback-id | lo local-id]
Parameters
vlan vlan‐id |
loopback loopback‐id |
lo local‐id
Defaults
If interface type is not specified, information for all routing interfaces will be displayed.
16-2 IP Configuration
Enter (in Global Configuration
Mode)...
vlan vlan-id
loopback loopback-id
lo local-id
(Optional) Displays interface information for a specific VLAN,
loopback, or local interface. This interface must be configured for IP
routing as described in "Pre‐Routing Configuration Tasks" on
page 2‐100.
Resulting Prompt...
Matrix>Router (config-if(Vlan 1))#
Matrix>Router (config-if (Lpbk 1))#
Matrix>Router (config-if (Lo 1))#
21.
Refer to page...
show interface
2‐9.
16-2
16-3
16-4
16-5
16-6
16-7