No Shutdown - Enterasys Matrix DFE-Gold Series Configuration Manual

no shutdown

Usage
Each Enterasys Matrix Series routing module or standalone device supports up to 96 routing
interfaces, with up to 50 secondary addresses (200 maximum per router) allowed for each primary
IP address.
The "no" form of this command removes the specified IP address and disables the interface for IP
processing.
Example
This example sets the IP address to 192.168.1.1 and the network mask to 255.255.255.0 for VLAN 1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip address 192.168.1.1 255.255.255.0
no shutdown
Use this command to enable an interface for IP routing and to allow the interface to automatically
be enabled at device startup.
Syntax
no shutdown
Parameters
None.
Defaults
None.
Mode
Router command, Interface configuration: Matrix>Router(config‐if(Vlan 1))#
Usage
The shutdown form of this command disables an interface for IP routing.
Example
This example shows how to enable VLAN 1 for IP routing:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#no shutdown
Configuring Routing Interface Settings
Enterasys Matrix DFE-Gold Series Configuration Guide 16-7