Clear Spantree Portpri; Set Spantree Porthello - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Port Parameters

clear spantree portpri

Use this command to reset the bridge priority of a Spanning Tree port to a default value of 128.
Syntax
clear spantree portpri port-string [sid sid]
Parameters
port‐string
sid sid
Defaults
If sid is not specified, port priority will be set for Spanning Tree 0.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the priority of fe.1.3 to 128 on SID 1:
Matrix(rw)->clear spantree portpri fe.1.3 sid 1:

set spantree porthello

Use this command to set the hello time for one or more Spanning Tree ports. This is the time
interval (in seconds) the port(s) will transmit BPDUs.
Syntax
set spantree porthello port-string interval
Parameters
port‐string
interval
Defaults
None.
Mode
Switch command, Read‐Write.
6-56 Spanning Tree Configuration
Specifies the port(s) for which to set Spanning Tree port priority. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
(Optional) Resets the port priority for a specific Spanning Tree
identifier. Valid values are 0 ‐ 4094. If not specified, SID 0 will be
assumed.
Specifies the port(s) for which to set hello time.
Specifies the number of seconds the system waits before broadcasting a
bridge hello message. Valid values are 1 ‐ 10.
clear spantree portpri