Receive-Interface - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring RIP
Mode
Router command, Router configuration: Matrix>Router(config‐router)#
Usage
This command does not prevent RIP from monitoring updates on the interface.
The "no" form of this command disables passive interface.
Example
This example shows how to set VLAN 2 as a passive interface. No RIP updates will be transmitted
on VLAN 2:
Matrix>Router(config)#router rip
Matrix>Router(config-router)#passive-interface vlan 2

receive-interface

Use this command to allow RIP to receive update packets on an interface. This does not affect the
sending of RIP updates on the specified interface.
Syntax
receive-interface vlan vlan-id
no receive-interface vlan vlan-id
Parameters
vlan‐id
Defaults
None.
Mode
Router command, Router configuration: Matrix>Router(config‐router)#
Usage
The "no" form of this command denies the reception of RIP updates.
Example
This example shows how to deny the reception of RIP updates on VLAN 2:
Matrix>Router(config)#router rip
Matrix>Router(config-router)#no receive-interface vlan 2
21-16 Routing Protocol Configuration
Specifies the number of the VLAN to make a receive interface. This
VLAN must be configured for IP routing as described in "Pre‐Routing
Configuration Tasks" on page 2‐100.
receive-interface