Clear Flowlimit Action - Enterasys Matrix DFE-Gold Series Configuration Manual

clear flowlimit action

drop
disable
userport | serverport
| aggregateduser |
interswitchlink |
unspecified
Defaults
• If action is not specified, no action will be applied.
• If classification port type is not specified, none will be applied.
Mode
Switch command, Read‐Write.
Example
This example shows how to set flow limiting action 1 to discard all flows exceeding flow limit 1 on
ports classified as user ports:
Matrix(rw)->set flowlimit action 1 discard userport
clear flowlimit action
Use this command to remove a flow limiting action configuration.
Syntax
clear flowlimit {action1 | action2} [notify] [drop] [disable] [userport |
serverport | aggregateduser | interswitchlink | unspecified]
Parameters
action1 | action2
notify
drop
(Optional) When flow limit is reached, drops excess flows and discard
packets.
(Optional) When flow limit is reached, disables the interface (if the set
flowlimit shutdown function is enabled as described in "set flowlimit
shutdown" on page 24‐32). This will clear all FST settings on the port.
(Optional) Assigns this action configuration to the user classification
port type:
• user port
• server port
• aggregation port
• inter‐switch link
• unspecified port
Specifies the configuration to be removed as action 1 or 2.
(Optional) Removes the notify action.
(Optional) Removes the drop action.
Enterasys Matrix DFE-Gold Series Configuration Guide 24-29
Configuring Flow Setup Throttling (FST)