Set Mgmt-Auth-Notify - Enterasys Matrix DFE-Gold Series Configuration Manual

set mgmt-auth-notify

ssh
telnet
web
set mgmt-auth-notify
Use this command to either enable or disable the Management Authentication Notification MIB.
By selecting the optional Management access type, a user can specifically enable or disable a single
access type, multiple access types or all of the access types. The default setting is that all
Management Authentication Notification types are enabled.
Syntax
set mgmt-auth-notify {enable | disable}{console | ssh | telnet | web}
Parameters
enable
disable
console
ssh
telnet
web
Defaults
If none of the optional Management Authentication Access types are entered, than all
authentications types listed above will either be enabled or disabled.
Mode
Switch command, Read‐Write.
Usage
Insure that SNMP is correctly configured on the DFE in order to send these notifications, refer to
the following chapter for configuring SNMP (Chapter 5).
Examples
This example shows how to set all the authentication types to be disabled on the Management
Authentication Notification MIB. That information is then displayed with the show command:
Matrix(su)->set mgmt-auth-notify disable
Matrix(su)->show mgmt-auth-notify
Management Type
---------------
console
ssh
telnet
web
enabled
enabled
enabled
Enables selected or all notifications.
Disables selected or all notifications.
(Optional) sets the console authentications
(Optional) sets SSH authentications
(Optional) sets telnet authentications
(Optional) sets web authentications
Status
--------
disabled
disabled
disabled
disabled
Managing the Management Authentication Notification MIB
Enterasys Matrix DFE-Gold Series Configuration Guide 2-27