Clear Spantree Spanguard; Show Spantree Spanguardtimeout - Enterasys Matrix DFE-Gold Series Configuration Manual

clear spantree spanguard

Example
This example shows how to enable the span guard function:
Matrix(rw)->set spantree spanguard enable
clear spantree spanguard
Use this command to resets the status of the Spanning Tree span guard function to disabled.
Syntax
clear spantree spanguard
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the status of the span guard function to disabled:
Matrix(rw)->clear spantree spanguard

show spantree spanguardtimeout

Use this command to display the Spanning Tree span guard timeout setting.
Syntax
show spantree spanguardtimeout
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the span guard timeout setting:
Matrix(rw)->show spantree spanguardtimeout
spanguard timeout is set at 300 seconds.
Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-37