Set Movedaddrtrap - Enterasys Matrix DFE-Gold Series Configuration Manual

set movedaddrtrap

Parameters
port‐string
Defaults
If port‐string is not specified, MAC address traps for all ports will be displayed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the status of MAC address traps on ge.1.1 through 3:
Matrix(rw)->show movedaddrtrap ge.1.1-3
Moved Address Traps Globally enabled
Port
--------- ------------
ge.1.1
ge.1.2
ge.1.3
set movedaddrtrap
Use this command to enable or disable SNMP trap messaging, globally or on one or more ports,
when moved source MAC addresses are detected.
Syntax
set movedaddrtrap [port-string] {enable | disable}
Parameters
port‐string
enable | disable
Defaults
If port‐string is not specified, MAC address traps will be globally enabled or disabled.
Mode
Switch command, Read‐Write.
(Optional) Displays MAC address traps for specific port(s). For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
Enable State
enabled
enabled
enabled
(Optional) Specifies the port(s) on which to enable or disable MAC
address traps. For a detailed description of possible port‐string values,
refer to "Port String Syntax Used in the CLI" on page 4‐2.
Enables or disables SNMP trap messaging when moved source MAC
addresses are detected.
Managing Switch Network Addresses and Routes
Enterasys Matrix DFE-Gold Series Configuration Guide 12-15