Set Port Flowcontrol; Show Port Flow Control Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

Setting Flow Control
Table 4‐4 provides an explanation of the command output.
Table 4-4 show port flow control Output Details
Output...
Port
TX Admin
TX Oper
RX Admin
RX Oper
TX Pause Count
RX Pause Count

set port flowcontrol

Use this command to enable or disable flow control settings for one or more ports.
Syntax
set port flowcontrol port-string {receive | send | both}{enable | disable}
Parameters
port‐string
receive | send | both
enable | disable
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to enable ports fe.3.1 through 5 to send and receive flow control packets:
Matrix(rw)->set port flowcontrol fe.3.1-5 both enable
4-38 Port Configuration
What it displays...
Port designation. For a detailed description of possible port-string
values, refer to "Port String Syntax Used in the
Whether or not the port is administratively enabled or disabled for
sending flow control frames.
Whether or not the port is operationally enabled or disabled for
sending flow control frames.
Whether or not the port is administratively enabled or disabled for
acknowledging received flow control frames.
Whether or not the port is operationally enabled or disabled for
acknowledging received flow control frames.
Number of Pause frames transmitted.
Number of Pause frames received.
Specifies port(s) for which to enable or disable flow control. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
Enables or disables the port(s) to receive, send, or receive and send flow
control packets.
Enables or disables flow control settings.
set port flowcontrol
CLI" on page 4-2.