Clear Spantree Fwddelay; Show Spantree Autoedge - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Bridge Parameters
addition, each port needs time to listen for conflicting information that would make it return to a
blocking state; otherwise, temporary data loops might result.
Example
This example shows how to globally set the bridge forward delay to 16 seconds:
Matrix(rw)->set spantree fwddelay 16

clear spantree fwddelay

Use this command to reset the Spanning Tree forward delay to the default setting of 15 seconds.
Syntax
clear spantree fwddelay
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to globally reset the bridge forward delay:
Matrix(rw)->clear spantree fwddelay

show spantree autoedge

Use this command to display the status of automatic edge port detection.
Syntax
show spantree autoedge
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
6-28 Spanning Tree Configuration
clear spantree fwddelay