Commands; Show Cdp; Enterasys Discovery Protocol; Purpose - Enterasys Matrix DFE-Gold Series Configuration Manual

show cdp

Enterasys Discovery Protocol

Purpose

To enable and configure the Enterasys Discovery Protocol (CDP), used to discover network
topology. When enabled, CDP allows Enterasys devices to send periodic PDUs about themselves
to neighboring devices.

Commands

For information about...
show cdp
set cdp state
set cdp auth
set cdp interval
set cdp hold-time
clear cdp
show cdp
Use this command to display the status of the CDP discovery protocol and message interval on
one or more ports.
Syntax
show cdp [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, all CDP information will be displayed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display CDP information for ports fe.1.1 through fe.1.9:
Matrix(rw)->show cdp fe.1.1-9
CDP Global Status
CDP Versions Supported
CDP Hold Time
(Optional) Displays CDP status for a specific port. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
: enabled
: 0x0 0x38
: 180
Enterasys Matrix DFE-Gold Series Configuration Guide 3-3
Enterasys Discovery Protocol
Refer to page...
3-3
3-4
3-5
3-6
3-6
3-7