Configuring OSPF
debug ip ospf
Use this command to enable OSPF protocol debugging output.
Syntax
debug ip ospf {subsystem}
no debug ip ospf {subsystem}
Parameters
subsystem
Defaults
None.
Mode
Router command, Privileged EXEC: Matrix>Router#
Usage
The "no" form of this command disables OSPF protocol debugging output.
Example
This example shows how to enable OSPF protocol debugging output to display information about
Link State Advertisement generation:
Matrix>Router#debug ip ospf lsa-generation
rfc1583compatible
Use this command to enable the OSPF router for RFC 1583 compatibility.
Syntax
rfc1583compatible
no rfc1583compatible
Parameters
None.
Defaults
None.
21-50 Routing Protocol Configuration
Specifies the OSPF subsystem for which protocol debugging will be
enabled. Valid entries and their associated outputs are:
•
adj ‐ OSPF adjacency events
•
flood ‐ OSPF flooding
•
lsa‐generation ‐ OSPF Link State Advertisement generation
•
packet ‐ OSPF packets
•
retransmission ‐ OSPF retransmission events
debug ip ospf
Need help?
Do you have a question about the Enterasys Matrix DFE-Gold Series and is the answer not in the manual?