Show Igmp Reporters - Enterasys Matrix DFE-Gold Series Configuration Manual

show igmp reporters

Example
This example shows how to display igmp information for vlan 12:
Matrix(rw)->show igmp vlan 12
IGMP Vlan 12 Info
IGMP query state
QueryInterval(sec.)
Status
IGMP Version
Querier
QueryMaxResponseTime(sec.)
Robustness
LastMemberQueryIntvl(sec.)
QuerierUpTime
Router(s) on ports
Egressing ports
show igmp reporters
Use this command to display IGMP reporter information.
Syntax
show igmp reporters [portlist portlist] [group group] [vlan-list vlan-list] [sip
sip]
Parameters
portlist portlist
group group
vlan‐list vlan‐list
sip sip
Defaults
If no parameters are specified, all IGMP reporter information is displayed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the all IGMP reporter information :
Matrix(rw)->show igmp reporters
IGMP Reporters
Port
---------------------------------------------------------------
lag.0.2
: Enabled
: 125
: Active
: 2
: 2.25.0.1
: 10
: 2
: 10
: 4 D
: none.
: lag.0.1-2,4
(Optional) Port or range of ports.
(Optional) Group IP address (none means show all groups)
(Optional) VLAN ID or range of IDs (1‐4094)
(Optional) Source IP address (none means show all sips)
Group Address Vlan Source IP ExpireTime(Sec) Flags
224.0.0.251 1
23 H 8 M
Any 252
Enterasys Matrix DFE-Gold Series Configuration Guide 9-15
Configuring IGMP
DYNAMIC