Show Ip Dhcp Binding - Enterasys Matrix DFE-Gold Series Configuration Manual

show ip dhcp binding

Parameters
hardware‐address
type
Defaults
If type is not specified, Ethernet will be applied.
Mode
Router command, Any DHCP configuration mode.
Usage
This command also enables DHCP host configuration mode.
The "no" form of this command removes the hardware address.
Example
This example shows how to specify 0001.f401.2710 as an Ethernet MAC address for the
"localpool" address pool:
Matrix>Router(config)#ip dhcp pool localpool
Matrix>Router(config-dhcp-pool)#hardware-address 0001.f401.2710 ethernet
show ip dhcp binding
Use this command to display information about one or all DHCP address bindings.
Syntax
show ip dhcp binding [ip-address]
Parameters
ip‐address
Defaults
If ip‐address is not specified, information about all address bindings will be shown.
Mode
Router command, Any DHCP configuration mode.
Specifies the MAC address of the client's hardware platform.
(Optional) Specifies a hardware protocol or client class name. Valid
values and their corresponding meanings are:
• 1 ‐ 10Mb Ethernet
• 6 or ieee802 ‐ IEEE 802 networks
• client‐class name ‐ Client class (configured as described in "show ip
dhcp binding" on page 20‐19).
• ethernet ‐ 10Mb Ethernet
(Optional) Displays bindings for a specific client IP address.
Enterasys Matrix DFE-Gold Series Configuration Guide 20-19
DHCP Overview