Configuring Power Over Ethernet (Poe); Purpose; Commands; Show Inlinepower - Enterasys Matrix DFE-Gold Series Configuration Manual

show inlinepower

Configuring Power over Ethernet (PoE)

This section applies only to PoE-equipped Matrix devices. Consult the Installation Guide shipped with your
product to determine if it is PoE-equipped.

Purpose

To review and set PoE parameters, including the power available to the chassis, the usage
threshold for each module, whether or not SNMP trap messages will be sent when power status
changes, and per‐port PoE settings.

Commands

For information about...
show inlinepower
set inlinepower mode
clear inlinepower mode
set inlinepower available
clear inlinepower available
set inlinepower powertrap
clear inlinepower powertrap
set inlinepower assigned
clear inlinepower assigned
set inlinepower threshold
clear inlinepower threshold
set inlinepower management
clear inlinepower management
set inlinepower psetrap
clear inlinepower psetrap
show port inlinepower
set port inlinepower
clear port inlinepower
show inlinepower
Use this command to display device PoE properties.
Syntax
show inlinepower
Important Notice
Enterasys Matrix DFE-Gold Series Configuration Guide 2-61
Configuring Power over Ethernet (PoE)
Refer to page...
2-61
2-62
2-63
2-63
2-64
2-65
2-65
2-66
2-66
2-67
2-67
2-68
2-68
2-69
2-69
2-70
2-70
2-71