Interface - Enterasys Matrix DFE-Gold Series Configuration Manual

interface

Mode
Router command, Any router mode.
Example
This example shows how to display information for all interfaces configured on the router. In this
case, one loopback interface has been configured for routing. For a detailed description of this
output, refer to Table
Vlan 1 is Administratively DOWN
Vlan 1 is Operationally DOWN
Mac Address is: 0001.f4da.2cba
The name of this device is Vlan 1
The MTU is 1500 bytes
The bandwidth is 10000 Mb/s
Encapsulation ARPA, Loopback not set
ARP type: ARPA, ARP Timeout: 14400 seconds
lo is Administratively UP
lo is Operationally UP
Internet Address is 127.0.0.1, Subnet Mask is 255.255.255.0
The name of this device is lo
The MTU is 1500 bytes
The bandwidth is 10000 Mb/s
interface
Use this command to configure interfaces for IP routing.
Syntax
interface {vlan vlan-id | loopback loopback-id}
Parameters
vlan vlan‐id |
loopback loopback‐id
Defaults
None.
Mode
Router command, Global configuration mode: Matrix>Router(config)#
Usage
This command enables interface configuration mode from global configuration mode, and, if the
interface has not previously been created, this command creates a new routing interface. For
16‐2Matrix>Router#show interface :
Specifies the number of the VLAN or loopback interface to be
configured for routing. This interface must be configured for IP routing
as described in "Pre‐Routing Configuration Tasks" on page 2‐100.
Configuring Routing Interface Settings
Enterasys Matrix DFE-Gold Series Configuration Guide 16-3