Chapter 21: Routing Protocol Configuration; Activating Advanced Routing Features; Configuring Rip; Rip Configuration Task List And Commands - Enterasys Matrix DFE-Gold Series Configuration Manual

This chapter describes the Routing Protocol Configuration set of commands and how to use them.
For information about...

Activating Advanced Routing Features

Configuring RIP

Configuring OSPF
Configuring DVMRP
Configuring IRDP
Configuring VRRP
Activating Advanced Routing Features
In order to enable advanced routing protocols, such as OSPF and extended ACLs, on an Enterasys
Matrix Series device, you must purchase and activate a license key. If you have purchased an
advanced routing license, and have enabled routing on the device as described in previous
chapters, you can activate your license as described in "Activating Licensed Features" on
page 2‐58. If you wish to purchase an advanced routing license, contact Enterasys Networks Sales.
Configuring RIP

Purpose

To enable and configure the Routing Information Protocol (RIP).

RIP Configuration Task List and Commands

Table 21‐1 lists the tasks and commands associated with RIP configuration. Commands are
described in the associated section as shown.
Routing Protocol Configuration
Router: The commands covered in this chapter can be executed only when the device is in router
mode. For details on how to enable router configuration modes, refer to
Configuration Modes" on page 2-103.
Note: Enabling RIP with the router rip and network commands is required if you want to run RIP
on the device. All other tasks are optional.
Enterasys Matrix DFE-Gold Series Configuration Guide 21-1
21
"Enabling Router
Refer to page...
21-1
21-1
21-19
21-52
21-55
21-61