Set Inlinepower Powertrap; Clear Inlinepower Powertrap - Enterasys Matrix DFE-Gold Series Configuration Manual

set inlinepower powertrap

set inlinepower powertrap
Use this command to disable or enable the sending of an SNMP trap message whenever the status
of the chassis PoE power supplies or the PoE system redundancy changes.
Syntax
set inlinepower powertrap {disable | enable}
Parameters
disable | enable
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to enable a chassis power supplies trap:
Matrix(rw)->set inlinepower powertrap enable

clear inlinepower powertrap

Use this command to reset chassis power trap messaging back to the default state of disabled.
Syntax
clear inlinepower powertrap
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset chassis power trap messaging to disabled:
Matrix(rw)->clear inlinepower powertrap
Disables or enables a chassis power supplies trap messaging.
Enterasys Matrix DFE-Gold Series Configuration Guide 2-65
Configuring Power over Ethernet (PoE)