Set Port Speed; Show Port Duplex - Enterasys Matrix DFE-Gold Series Configuration Manual

set port speed

set port speed
Use this command to set the default speed of one or more ports. This setting only takes effect on
ports that have auto‐negotiation disabled.
Syntax
set port speed port-string {10 | 100 | 1000}
Parameters
port‐string
10 | 100 | 1000
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set Fast Ethernet port 3 in module3 to a port speed of 10 Mbps:
Matrix(rw)->set port speed fe.3.3 10

show port duplex

Use this command to display the default duplex setting (half or full) for one or more ports.
Syntax
show port duplex [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, default duplex settings for all ports will be displayed.
Mode
Switch command, Read‐Only.
Specifies the port(s) for which to a speed value will be set. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
Specifies the port speed. Valid values are: 10 Mbps, 100 Mbps, or
1000 Mbps.
(Optional) Displays default duplex setting(s) for specific port(s). For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
Enterasys Matrix DFE-Gold Series Configuration Guide 4-25
Setting Speed and Duplex Mode