Set Radius; Show Radius Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring RADIUS
Defaults
If no parameters are specified, all RADIUS configuration information will be displayed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display RADIUS configuration information:
Matrix(rw)->show radius
RADIUS state:
RADIUS retries:
RADIUS timeout:
RADIUS Server
-- --------------- ---------
1
Table 25‐4 provides an explanation of the command output.
Table 25-4 show radius Output Details
Output...
RADIUS state
RADIUS retries
RADIUS timeout
RADIUS Server

set radius

Use this command to enable, disable, or configure RADIUS authentication.
Syntax
set radius {[enable | disable] [retries number-of-retries]
[server {index ip-address port [secret-value]} [realm {management-access |
network-access | any} {index | all}]}
Parameters
enable | disable
retries
number-of-retries
25-54 Authentication Configuration
Enabled
2
3 seconds
IP Address Auth-Port
------------------
100.10.0.100 1812
What it displays...
Whether the RADIUS client is enabled or disabled.
Number of retry attempts before the RADIUS server times out. The
default value of 3 can be reset using the set radius command as
described in
Maximum amount of time (in seconds) to establish contact with the
RADIUS server before retry attempts begin. The default value of 20
can be reset using the set radius command as described in
radius" on page 25-54.
IP address, UDP authentication port, authentication realm type
(management, network or any), and status (whether or not the
RADIUS server has been configured).
Enables or disables the RADIUS client.
Specifies the number of retry attempts before the RADIUS server times
out. Valid values are from 1 to 10. Default is 3.
Realm-Type
-------
any
"set radius" on page 25-54.
set radius
Status --------
Active
"set
[timeout timeout]