Set Telnet - Enterasys Matrix DFE-Gold Series Configuration Manual

set telnet

set telnet
Use this command to enable or disable Telnet on the device.
Syntax
set telnet {enable | disable}{inbound | outbound | all}
Parameters
enable | disable
inbound | outbound
| all
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to disable inbound and outbound Telnet services:
Matrix(rw)->set telnet disable all
Disconnect all telnet sessions and disable now (y/n)? [n]: y
All telnet sessions have been terminated, telnet is now disabled.
telnet
Use this command to start a Telnet connection to a remote host. The Matrix Series device allows a
total of four inbound and / or outbound Telnet session to run simultaneously.
Syntax
telnet host [port]
Parameters
host
port
Defaults
If not specified, the default port number 23 will be used.
Mode
Switch command, Read‐Write.
Enables or disables Telnet services.
Specifies inbound service (the ability to Telnet to this device), outbound
service (the ability to Telnet to other devices), or all (both inbound and
outbound).
Specifies the name or IP address of the remote host.
(Optional) Specifies the server port number.
Enterasys Matrix DFE-Gold Series Configuration Guide 2-77
Starting and Configuring Telnet