Set Rmon Event Properties; Set Rmon Event Status - Enterasys Matrix DFE-Gold Series Configuration Manual

set rmon event properties

set rmon event properties
Use this command to configure an RMON event entry, or to create a new event entry with an
unused event index number.
Syntax
set rmon event properties index [description description] [type {none | log | trap
| both}] [community community] [owner owner]
Parameters
index
description description (Optional) Specifies a text string description of this event.
type none | log | trap
| both
community
community
owner owner
Defaults
• If description is not specified, none will be applied.
• If not specified, type none will be applied.
• If owner is not specified, monitor will be applied.
Mode
Switch command, Read‐Write.
Example
This example shows how to create and enable an RMON event entry called "STP topology
change" that will send both a log entry and an SNMP trap message to the "public" community:
Matrix(rw)->set rmon event properties 2 description "STP topology change" type
both community public owner Manager

set rmon event status

Use this command to enable an RMON event entry. An event entry describes the parameters of an
RMON event that can be triggered. Events can be fired by RMON alarms and can be configured to
create a log entry, generate a trap, or both.
Syntax
set rmon event status index enable
Specifies an index number for this entry. Maximum number of entries is
100. Maximum value is 65535.
(Optional) Specifies the type of RMON event notification as: none, a log
table entry, an SNMP trap, or both a log entry and a trap message.
(Optional) Specifies an SNMP community name to use if the message
type is set to trap. For details on setting SNMP traps and community
names, refer to "Configuring SNMP Target Addresses" on page 5‐29.
(Optional) Specifies the name of the entity that configured this entry.
Enterasys Matrix DFE-Gold Series Configuration Guide 11-25
Configuring RMON