Set Snmp Community - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring SNMP Users, Groups and Communities
Example
This example shows how to display information about the SNMP "public" community name. For
a description of this output, refer to "set snmp community" on page 5‐16:
Matrix(rw)->show snmp community public
--- Configured community strings ---
Name
Security name
Context
Transport tag
Storage type
Status

set snmp community

Use this command to configure an SNMP community group.
Syntax
set snmp community community [securityname securityname] [context context]
[transport transport] [volatile | nonvolatile]
Parameters
community
securityname
securityname
context context
transport transport
volatile | nonvolatile
Defaults
None.
Mode
Switch command, Read‐Write.
5-16 SNMP Configuration
= public
= public
=
=
= nonVolatile
= active
Specifies a community group name.
(Optional) Specifies an SNMP security name to associate with this
community. Default: If no security name is specified, the community
name is used.
(Optional) Specifies a subset of management information this
community will be allowed to access. Valid values are full or partial
context names of either MIB object IDs or router (the system designated
router mode module). Default: All MIB objects. To review all contexts
configured for the device, use the show snmp context command as
described in "show snmp context" on page 5‐23.
Note: Beginning with Release 6.0 do not specify the routing module ID as part
of the context. You must specify router for the system designated router mode
module.
(Optional) Specifies the set of transport endpoints from which SNMP
request with this community name will be accepted. Makes a link to a
target address table. Default: None.
(Optional) Specifies the storage type for these entries. Default:
nonvolatile.
set snmp community