Set Sntp Client - Enterasys Matrix DFE-Gold Series Configuration Manual

set sntp client

Table 13-1 show sntp Output Details (continued)
Output...
Client Mode
Broadcast Delay
Broadcast Count
Poll Interval
Poll Retry
Poll Timeout
SNTP Poll Requests
Last SNTP Update
Last SNTP Request
Last SNTP Status
SNTP-Server
Precedence
Status
set sntp client
Use this command to set the SNTP operation mode.
Syntax
set sntp client {broadcast | unicast | disable}
Parameters
broadcast
unicast
disable
Defaults
None.
What it displays...
Whether SNTP client is operating in unicast or broadcast mode. Set
using set sntp client command
Round trip delay for SNTP broadcast frames. Default of 3000
microseconds can be reset using the set sntp broadcastdelay
command ("set sntp
Number of SNTP broadcast frames received.
Interval between SNTP unicast requests. Default of 512 seconds can
be reset using the set sntp poll-interval command
interval" on page 13-6).
Number of poll retries to a unicast SNTP server. Default of 1 can be
reset using the set sntp poll-retry command
page 13-7).
Timeout for a response to a unicast SNTP request. Default of 5
seconds can be reset using set sntp poll-timeout command
sntp poll-timeout" on page 13-8).
Total number of SNTP poll requests.
Date and time of most recent SNTP update.
Date and time of most recent SNTP update.
Whether or not broadcast reception or unicast transmission and
reception was successful.
IP address(es) of SNTP server(s).
Precedence level of SNTP server in relation to its peers. Highest
precedence is 1 and lowest is 10. Default of 1 can be reset using the
set sntp server command
Whether or not the SNTP server is active.
Enables SNTP in broadcast client mode.
Enables SNTP in unicast (point‐to‐point) client mode. In this mode, the
client must supply the IP address from which to retrieve the current
time.
Disables SNTP.
Enterasys Matrix DFE-Gold Series Configuration Guide 13-3
Configuring Simple Network Time Protocol (SNTP)
("set sntp client" on page 13-3).
broadcastdelay" on page 13-5).
("set sntp
("set sntp server" on page 13-4).
("set sntp poll-
poll-retry" on
("clear