Set Summertime Recurring - Enterasys Matrix DFE-Gold Series Configuration Manual

set summertime recurring

end_hr_min
offset_minutes
Defaults
If an offset is not specified, none will be applied.
Mode
Switch command, Read‐Write.
Usage
These settings will be non‐recurring and will have to be reset annually.
Example
This example shows how to set a daylight savings time start date of April 4, 2004 at 2 a.m. and an
ending date of October 31, 2004 at 2 a.m. with an offset time of one hour:
Matrix(rw)->set summertime date April 4 2004 02:00 October 31 2004 02:00 60
set summertime recurring
Use this command to configure recurring daylight savings time settings.
Syntax
set summertime recurring start_week start_day start_month start_hr_min end_week
end_day end_month end_hr_min [offset_minutes]
Parameters
start_week
start_day
start_hr_min
end_week
end_day
end_hr_min
offset_minutes
Defaults
If an offset is not specified, none will be applied.
Specifies the time of day to end daylight savings time. Format is
hh:mm.
(Optional) Specifies the amount of time in minutes to offset daylight
savings time from the non‐daylight savings time system setting. Valid
values are 1 ‐ 1440.
Specifies the week of the month to restart daylight savings time. Valid
values are: first, second, third, fourth, and last.
Specifies the day of the week to restart daylight savings time.
Specifies the time of day to restart daylight savings time. Format is
hh:mm.
Specifies the week of the month to end daylight savings time.
Specifies the day of the week to end daylight savings time.
Specifies the time of day to end daylight savings time. Format is
hh:mm.
(Optional) Specifies the amount of time in minutes to offset daylight
savings time from the non‐daylight savings time system setting. Valid
values are 1 ‐ 1440.
Enterasys Matrix DFE-Gold Series Configuration Guide 2-43
Setting Basic Device Properties