Clear Spantree Porthello; Show Spantree Portcost - Enterasys Matrix DFE-Gold Series Configuration Manual

clear spantree porthello

Usage
This command can be executed only if bridge hello mode is disabled. For information on using the
set spantree bridgehellomode command, refer to "set spantree bridgehellomode" on page 6‐23.
Example
This example shows how to set the hello time to 3 seconds for port fe.1.4:
Matrix(rw)->set spantree porthello fe.1.4 3
clear spantree porthello
Use this command to reset the hello time for one or more Spanning Tree ports to the default of 2
seconds.
Syntax
clear spantree porthello port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the hello time to 2 seconds for port fe.1.4:
Matrix(rw)->clear spantree porthello fe.1.4

show spantree portcost

Use this command to display cost values assigned to one or more Spanning Tree ports.
Syntax
show spantree portcost [port port-string] [sid sid]
Parameters
port port‐string
sid sid
Defaults
• If port‐string is not specified, port cost will be displayed for all Spanning Tree ports.
Specifies the port(s) for which to reset hello time.
(Optional) Displays cost values for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
(Optional) Displays port cost for a specific Spanning Tree identifier.
Valid values are 0 ‐ 4094. If not specified, SID 0 will be assumed.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-57
Configuring Spanning Tree Port Parameters