Enterasys Matrix DFE-Gold Series Configuration Manual page 537

traceroute
‐d
‐t tos
‐F
‐g gateway
‐I
‐n
‐v
‐x
host
packetlen
Defaults
• If not specified, waittime will be set to 5 seconds.
• If not specified, first‐ttl will be set to 1 second.
• If not specified, max‐ttl will be set to 30 seconds.
• If not specified, port will be set to 33434.
• If not specified, nqueries will be set to 3.
• If ‐r is not specified, normal host routing tables will be used.
• If ‐d is not specified, the debug socket option will not be used.
• If not specified, tos will be set to 0.
• If ‐F is not specified, the 'don't fragment' bit will not be applied.
• If gateway is not specified, none will be applied.
• If ‐I is not specified, UDP datagrams will be used.
• If ‐v is not specified, summary output will be displayed.
• If ‐x is not specified, checksums will be calculated.
Mode
Switch command, Read‐Only.
Usage
Three UDP or ICMP probes will be transmitted for each hop between the source and the
traceroute destination.
(Optional) Sets the debug socket option.
(Optional) Sets the type of service (TOS) to be used in probe packets.
(Optional) Sets the 'don't fragment' bit.
(Optional) Specifies a loose source gateway (up to 8 can be specified), or
specifies a specific gateway, such as gw1.
(Optional) Specifies the use of ICMP echo requests rather than UDP
datagrams.
(Optional) Displays hop addresses numerically. (Supported in a future
release.)
(Optional) Displays verbose output, including the size and destination
of each response.
(Optional) Prevents traceroute from calculating checksums.
Specifies the host to which the route of an IP packet will be traced.
(Optional) Specifies the length of the probe packet.
Enterasys Matrix DFE-Gold Series Configuration Guide 12-7
Managing Switch Network Addresses and Routes