Set Port Negotiation; Show Port Mdix - Enterasys Matrix DFE-Gold Series Configuration Manual

set port negotiation

Mode
Switch command, Read‐Only.
Example
This example shows how to display auto‐negotiation status for 1‐Gigabit Ethernet port 14 in
module 3:
Matrix(rw)->show port negotiation ge.3.14
auto-negotiation is enabled on port ge.3.14.
set port negotiation
Use this command to enable or disable auto‐negotiation on one or more ports.
Syntax
set port negotiation port-string {enable | disable}
Parameters
port‐string
enable | disable
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to disable auto‐negotiation on 1‐Gigabit Ethernet port 3 in module 14:
Matrix(rw)->set port negotiation ge.3.14 disable

show port mdix

Use this command to display the MDI/MDIX mode on one or more ports. This function detects
and adapts to straight through (MDI) or cross‐over (MDIX) Ethernet cabling on switch ports.
Syntax
show port mdix [port-string] {all | auto | mdi | mdix}
Parameters
port‐string
all
Specifies the port(s) for which to enable or disable auto‐negotiation. For
a detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
Enables or disables auto‐negotiation.
(Optional) Displays mode for specific port(s). For a detailed description
of possible port‐string values, refer to "Port String Syntax Used in the
CLI" on page 4‐2.
Displays port(s) MDI and MDIX admin status.
Enterasys Matrix DFE-Gold Series Configuration Guide 4-31
Setting Auto-Negotiation and Advertised Ability