Set Cos Reference Irl; Clear Cos Reference Irl - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Policy Class of Service (CoS)
0.1
0.1
0.1
0.1

set cos reference irl

Use this command to set a Class of Service inbound rate limiting reference configuration.
Syntax
set cos reference irl group-type-index reference rate-limit number
Parameters
group‐type‐index
reference
rate‐limit
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to configure inbound rate limiting reference entry 0 for port group 0.1
referencing resources defined by IRL entry 0:
Matrix(rw)->set cos reference irl 0.1 0 rate-limit 0

clear cos reference irl

Use this command to clear one or all Class of Service inbound rate limiting reference
configurations.
Syntax
clear cos reference irl {all | group-type-index reference}
Parameters
all | group‐type‐index
reference
8-36 Policy Classification Configuration
12 txq 3
13 txq 3
14 txq 3
15 txq 3
Specifies an inbound rate limiting port group/type index for this entry.
Valid entries are in the form of group.type. Group can be 0‐7, with 0
designating the default group, and 1‐7 reserved for user‐defined
groups. Default port type values cannot be changed, and are 0 for the
7GR4270‐12, 7G4270‐12, 7G4270‐09, and 7G4270‐10 DFE modules, and 1
for all other modules.
Specifies a reference number to be associated with this entry.
number
Specifies a rate limiter resource ID to bind to this entry.
Clears all non‐default inbound rate limiting reference entries or a
specific entry.
Specifies a reference number of the entry to be cleared.
set cos reference irl