Show Nodealias Config - Enterasys Matrix DFE-Gold Series Configuration Manual

show nodealias config

Parameters
ip | apl | mac | hsrp |
dhcps | dhcpc |
bootps | bootpc |
ospf | vrrp | ipx |
xrip | xsap | ipx20 |
rtmp | netBios | nbt |
bgp | rip | igrp | dec
| bpdu | udp
ip‐address ip‐address
port‐string
Defaults
• If ip‐address is not specified for the IP protocol, IP‐related entries will be displayed from all
source addresses.
• If port‐string is not specified, node alias entries will be displayed for all ports.
Mode
Switch command, Read‐Only.
Example
This example shows how to display node alias entries for IP traffic on ge.3.16. Refer back to
Table 14‐1 for a description of the command output.
Matrix(rw)->show nodealias protocol ip ge.3.16
Port: ge.3.16 Time: 1 days 03 hrs 33 mins 47 secs
--------------------------------------------------------
Alias ID
Vlan ID
Protocol
show nodealias config
Use this command to display node alias configuration settings on one or more ports.
Syntax
show nodealias config [port-string]
Parameters
port‐string
Specifies the protocol for which to display node alias entries. Refer back
show nodealias mac ("show nodealias mac" on page 14‐2) for a
detailed description of these parameters.
(Optional) Used for IP protocol only, displays node alias entries for a
specific source address.
(Optional) Displays node alias entries for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
= 1533917141 Active
= 1 MAC Address
= ip Source IP
(Optional) Displays node alias configuration settings for specific
port(s). For a detailed description of possible port‐string values, refer to
"Port String Syntax Used in the CLI" on page 4‐2.
= true
= 00-e0-63-04-7b-00
= 199.45.62.25
Enterasys Matrix DFE-Gold Series Configuration Guide 14-5
Configuring Node Aliases