Clear Radius - Enterasys Matrix DFE-Gold Series Configuration Manual

clear radius

timeout timeout
server index ip_address
port
secret‐value
realm management
‐access | network‐
access | any
index | all
Defaults
• If secret‐value is not specified, none will be applied.
• If realm is not specified, any authentication will be allowed.
Mode
Switch command, Read‐Write.
Usage
The RADIUS client can only be enabled on the switch once a RADIUS server is online, and its IP
address(es) has been configured with the same password the RADIUS client will use.
Examples
This example shows how to enable the RADIUS client for authenticating with RADIUS server 1 at
IP address 10.1.6.203, UDP authentication port 1812, and an authentication password of
"pwsecret." As previously noted, the "server secret" password entered here must match that
already configured as the Read‐Write (rw) password on the RADIUS server:
Matrix(rw)->set radius server 1 10.1.6.203 1812 pwsecret
This example shows how to restrict all RADIUS servers to authenticate management access only
Matrix(rw)->set radius realm management-access all
This example shows how to set the RADIUS timeout to 5 seconds:
Matrix(rw)->set radius timeout 5
This example shows how to set RADIUS retries to 10:
Matrix(rw)->set radius retries 10
clear radius
Use this command to clear RADIUS server settings.
Syntax
clear radius [state] [retries] [timeout] [server [index | all] [realm {index |
all}]
Specifies the maximum amount of time (in seconds) to establish contact
with the RADIUS server before retry attempts begin. Valid values are
from 1 to 30. Default is 20 seconds.
Specifies the index number, IP address and the UDP authentication port
for the RADIUS server.
(Optional) Specifies an encryption key to be used for authentication
between the RADIUS client and server.
(Optional) Restricts the RADIUS server realm to management or
network access authentication, or allows it to perform all
authentications.
Applies the server realm setting to a specific server or to all servers.
Enterasys Matrix DFE-Gold Series Configuration Guide 25-55
Configuring RADIUS