Set Lacp Aadminkey; Clear Lacp - Enterasys Matrix DFE-Gold Series Configuration Manual

set lacp aadminkey

Usage
Only one LACP system priority can be set on a Matrix Series device, using either this command, or
the set port lacp command ("set port lacp" on page 4‐66).
LACP uses this value to determine aggregation precedence. If there are two partner devices
competing for the same aggregator, LACP compares the LAG IDs for each grouping of ports. The
LAG with the lower LAG ID is given precedence and will be allowed to use the aggregator.
Example
This example shows how to set the LACP system priority to 1000:
Matrix(rw)->set lacp asyspri 1000
set lacp aadminkey
Use this command to set the administratively assigned key for one or more aggregator ports.
LACP will use this value to form an oper key. Only underlying physical ports with oper keys
matching those of their aggregators will be allowed to aggregate.
Syntax
set lacp aadminkey port-string value
Parameters
port‐string
value
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the LACP admin key to 2000 for LAG port 4:
Matrix(rw)->set lacp aadminkey lag.0.484 2000

clear lacp

Use this command to clear LACP system priority or admin key settings.
Syntax
clear lacp {[asyspri] [aadminkey port-string]}
Parameters
asyspri
aadminkey port‐string Clears admin keys for one or more ports.
Specifies the LAG port(s) on which to assign an admin key.
Specifies an admin key value to set. Valid values are 0 to 65535.
Clears system priority.
Enterasys Matrix DFE-Gold Series Configuration Guide 4-61
Configuring LACP