Set Macauthentication Quietperiod; Clear Macauthentication Quietperiod - Enterasys Matrix DFE-Gold Series Configuration Manual

set macauthentication quietperiod

set macauthentication quietperiod
Use this command to enable a reauthentication attempt for failed entries at the period specified in
seconds.
Syntax
set macauthentication quietperiod time port-string
Parameters
time
port‐string
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
Default value is 0 (never).
Example
This example shows how to set the macauthentication quiet period to 120 seconds
(2 minutes) on ge.2.1 through 5:
Matrix(rw)->set macauthentication quiet period 120 ge.2.1-5

clear macauthentication quietperiod

Use this command to clear the macauthentication quiet period on one or more ports to the default
value.
Syntax
clear macauthentication quietperiod [port-string]
Parameters
port‐string
Defaults
None.
Mode
Switch command, Read‐Write.
Specifies the number of seconds between reauthentication attempts.
Valid values are 0 ‐ 4294967295.
Specifies the port(s) on which to set the macauthentication quiet period.
For a detailed description of possible port‐string values, refer to "Port
String Syntax Used in the CLI" on page 4‐2.
(Optional) Clears the macauthentication quiet period on specific port(s).
For a detailed description of possible port‐string values, refer to "Port
String Syntax Used in the CLI" on page 4‐2.
Enterasys Matrix DFE-Gold Series Configuration Guide 25-37
Configuring MAC Authentication