Ip Dhcp Server; Ip Local Pool - Enterasys Matrix DFE-Gold Series Configuration Manual

DHCP Overview
For information about...
clear ip dhcp binding
show ip dhcp server statistics
clear ip dhcp server statistics

ip dhcp server

Use this command to enable DHCP server features on a routing interface.
Syntax
ip dhcp server
no ip dhcp
Parameters
None.
Defaults
None.
Mode
Router command, Interface configuration: Matrix>Router(config‐if(Vlan 1))#
Usage
The "no" form of this command disables DHCP server features on one or all routing interfaces.
Example
This example shows how to enable DHCP server on VLAN 1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))ip dhcp server

ip local pool

Use this command to configure a local address pool to use as a DHCP subnet. This defines the
range of IP addresses to be used by DHCP server and enables IP local pool configuration mode.
Syntax
ip local pool name subnet mask
no ip local pool name subnet mask
Parameters
name
subnet
mask
20-6 DHCP Configuration
Specifies a name for the local address pool.
Specifies an IP subnet for the local address pool.
Specifies a subnet mask for the local address pool. Valid entries are:
x.x.x.x or /x.
ip dhcp server
Refer to page...
20-20
20-20
20-22