Configuring PIM
For information about...
show ip mforward
show ip rpf
ip pim sparse mode
Use this command to enable Protocol Independent Multicast (PIM) Sparse Mode (SM) on a
routing interface.
Syntax
ip pim sparse-mode
no ip pim sparse-mode
Parameters
None.
Defaults
None.
Mode
Router command, Interface configuration: Matrix>Router(config‐if(Vlan 1))#
Usage
The "no" form of this command disables PIM on an interface.
Example
This example enables PIM sparse mode on VLAN 1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip pim sparse-mode
ip pim bsr-candidate
Use this command to enable the router to announce its candidacy as a BootStrap Router (BSR).
Syntax
ip pim bsr-candidate pim-interface [hash-mask-length] [priority]]
no ip bsr-candidate
17-2 PIM Configuration
ip pim sparse mode
Refer to page...
17-11
17-12