Clear Router Limits (Lsnat) - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Load Sharing Network Address Translation (LSNAT)
Defaults
• If not specified, maximum bindings will be set to the default value of 5000.
• If not specified, cache size will be set to the default value of 1000.
• If not specified, maximum configs will be set to the default value of 50. That is, up to 50 server
farms, 50 virtual servers, and 50 direct access entries can be configured, and up to 500 real
servers and 500 client access entries can be configured.
Mode
Switch command, Read‐Write.
Usage
The chassis or system must be rebooted for any new change to take effect.
This command must be executed from the switch CLI.
Example
This example shows how to set the LSNAT configuration limit to 25. This means that up to 25
server farms, 25 virtual servers, and 25 direct access entries can be configured, and up to 250 real
servers and 250 client access entries can be configured.
Matrix(rw)->set router limits lsnat-configs 25

clear router limits (LSNAT)

Use this command to reset chassis‐based LSNAT limits to default values.
Syntax
clear router limits [lsnat-bindings] | [lsnat-cache] | [lsnat-configs]
Parameters
lsnat‐bindings
lsnat‐cache
lsnat‐configs
Defaults
If no options are specified, all LSNAT limits will be reset.
19-34 LSNAT Configuration
Note: Router limits can also be set in the following contexts:
To set NAT router limits see
To set TWCB router limits see
(Optional) Resets the LSNAT maximum bindings limit to the default
value of 5000.
(Optional) Resets the LSNAT cache size limit to the default value of
2000.
(Optional) Resets the LSNAT configuration limit to the default value of
50.
"set router limits (NAT)" on page 18-14.
"set router limits (TWCB)" on page 23-15.
clear router limits (LSNAT)