no ip routing
Performing a Basic Router Configuration
Using Router-Only Config Files
Although the Enterasys Matrix Series' single configuration interface provides one set of
commands to perform both switch and router configuration, it is still possible to use router‐only
commands to configure the router. To do so, you need to add router config wrappers to your
existing router config files, as shown in Figure
Figure 16-1
begin router
enable
conf t
write file
exit
disable
exit
end router
Displaying or Writing the Current Config to a File
The Enterasys Matrix Series' single configuration interface allows you use the show config
command to display or write the current router configuration to a file. For details, refer to "show
config" on page 2‐85.
Configuring the Router
You can configure the router using either of the following methods.
Using a downloaded file...
1.
Download a router config file to the standalone or chassis using the copy command as
described in "copy" on page 2‐86.
2.
Run the configure command using the downloaded config file as described in "configure" on
page 2‐86.
Creating and saving a custom file...
1.
Enable the router as described in "Enabling Router Configuration Modes" on page 2‐103 and
configure it manually. (Refer back to Figure
2.
Save the configuration using the write file command as described in "write" on page 16‐9.
Moving a Config File from Another Routing Module
To copy a router configuration from one module to another, proceed as follows:
1.
From the routing module in which you wish to copy a config file, perform a show config on
the file as described in "show config" on page 2‐85.
Example of a Simple Enterasys Matrix Series Router Config File
Performing a Basic Router Configuration
16‐1.
16‐1 for an example of a basic config file.)
Enterasys Matrix DFE-Gold Series Configuration Guide 16-11
Need help?
Do you have a question about the Enterasys Matrix DFE-Gold Series and is the answer not in the manual?