Ip Rip Send Version; Ip Rip Receive Version - Enterasys Matrix DFE-Gold Series Configuration Manual

ip rip send version

Example
This example shows how to set RIP timers to a 5 second update time, a 10 second invalid interval,
a 20 second holdown time, and a 60 second flush time:
Matrix>Router(config)#router rip
Matrix>Router(config-router)#timers basic 5 10 20 60
ip rip send version
Use this command to set the RIP version(s) for update packets transmitted on an interface.
Syntax
ip rip send version {1 | 2 | r1compatible}
no ip rip send version
Parameters
1
2
r1compatible
Defaults
None.
Mode
Router command, Interface configuration: Matrix>Router(config‐if(Vlan 1))#
Usage
The "no" form of this command restores the version of update packets that was transmitted by the
RIP module.
Example
This example shows how to set the RIP send version to 2 for packets transmitted on VLAN 1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip rip send version 2

ip rip receive version

Use this command to set the RIP version(s) for update packets accepted on the interface.
Syntax
ip rip receive version {1 | 2 | 1 2 | none}
no ip rip receive version
Specifies RIP version 1.
Specifies RIP version 2.
Specifies that packets be sent as version 2 packets, but transmits these as
broadcast packets rather than multicast packets so that systems which
only understand RIP version 1 can receive them.
Enterasys Matrix DFE-Gold Series Configuration Guide 21-7
Configuring RIP