Show Ip Ospf Border-Routers; Show Ip Ospf Interface - Enterasys Matrix DFE-Gold Series Configuration Manual

show ip ospf border-routers

Table 21-3 show ip ospf database Output Details (continued)
Output...
Checksum
LinkCount
show ip ospf border-routers
Use this command to display information about OSPF internal entries to Area Border Routers
(ABRs) and Autonomous System Boundary Routers (ASBRs).
Syntax
show ip ospf border-routers
Parameters
None.
Defaults
None.
Mode
Router command, Any router mode.
Example
This example shows how to display information about OSPF border routers. The first line of this
output shows that an intra‐area route has been established to destination border router
192.168.22.1 via neighboring router 192.168.11.1 on the VLAN 2 interface in area 0. The OSPF cost
of this route is 64, and it carries an SPF calculation of 10. The destination router is an ABR:
Matrix>Router#show ip ospf border-routers
OSPF internal
Codes: i - Intra-area route, I - Inter-area route
i 192.168.22.1 [64] via 192.168.11.1, VLAN2, ABR, Area 0, SPF 10
i 192.168.22.1 [64] via 192.168.11.1, VLAN2, ABR, Area 4, SPF 10
i 192.168.44.1 [64] via 192.168.33.1, VLAN1, ABR, Area 0, SPF 10
i 192.168.44.1 [64] via 192.168.33.1, VLAN1, ABR, Area 2, SPF 7
i 192.168.44.2 [128] via 192.168.33.1, VLAN1, ABR, Area 0, SPF 10
i 192.168.44.2 [128] via 192.168.11.1, VLAN2, ABR, Area 0, SPF 10

show ip ospf interface

Use this command to display OSPF interface related information, including network type, priority,
cost, hello interval, and dead interval.
Syntax
show ip ospf interface [vlan vlan-id]
What it displays...
Field in the link state record used to verify the contents upon receipt by
another router.
Link count of router link state records. This number is equal to, or
greater than, the number of active OSPF interfaces on the originating
router.
Enterasys Matrix DFE-Gold Series Configuration Guide 21-45
Configuring OSPF