Set History; Show Netstat - Enterasys Matrix DFE-Gold Series Configuration Manual

set history

set history
Use this command to set the size of the history buffer.
Syntax
set history size [default]
Parameters
size
default
Defaults
If default is not specified, the history setting will not be persistent.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the size of the command history buffer to 3 lines and make this the
default setting:
Matrix(rw)->set history 3 default

show netstat

Use this command to display statistics for the switch's active network connections.
Syntax
show netstat [icmp | ip | routes | stats | tcp | udp]
Parameters
icmp
ip
routes
stats
tcp
udp
Defaults
If no parameters are specified, show netstat will be executed as shown in the example below.
Mode
Switch command, Read‐Only.
Specifies the size of the history buffer in lines. Valid values are 1 to 100.
(Optional) Makes this setting persist for all future sessions.
(Optional) Shows Internet Control Message Protocol (ICMP) statistics.
(Optional) Shows Internet Protocol (IP) statistics.
(Optional) Shows the IP routing table.
(Optional) Shows all statistics for TCP, UDP, IP, and ICMP.
(Optional) Shows Transmission Control Protocol (TCP) statistics.
(Optional) Shows User Datagram Protocol (UDP) statistics.
Enterasys Matrix DFE-Gold Series Configuration Guide 11-3
Monitoring Network Events and Status