set pwa initialize
Usage
When enhanced mode is enabled (as described in "set pwa enhancedmode" on page 25‐20), PWA
will use a guest password and guest user name to grant network access with default policy
privileges to users without established login names and passwords.
Example
This example shows how to enable PWA guest networking with RADIUS authentication:
Matrix(rw)->set pwa guestnetworking authradius
set pwa initialize
Use this command to initialize a PWA port to its default unauthenticated state.
Syntax
set pwa initialize [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, all ports will be initialized.
Mode
Read‐Write.
Example
This example shows how to initialize ports fe.1.5‐7:
Matrix(rw)->set pwa initialize fe.1.5-7
set pwa quietperiod
Use this command to set the amount of time a port will remain in the held state after a user
unsuccessfully attempts to log on to the network.
Syntax
set pwa quietperiod time [port-string]
Parameters
time
port‐string
(Optional) Initializes specific port(s). For a detailed description of
possible port‐string values, refer to "Port String Syntax Used in the CLI"
on page 4‐2.
Specifies quiet time in seconds.
(Optional) Sets the quiet period for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
Enterasys Matrix DFE-Gold Series Configuration Guide 25-23
Configuring Port Web Authentication (PWA)