Monitoring Network Events and Status
show users
Use this command to display information about the active console port or Telnet session(s) logged
in to the switch.
Syntax
show users
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to use the show users command. In this output, there are two Telnet
users logged in with Read‐Write access privileges from IP addresses 134.141.192.119 and
134.141.192.18:
Matrix(rw)->show users
Session
-------- ----- --------------------------
* telnet
telnet
tell
Use this command to send a message to one or all users.
Syntax
tell {dest | all} message
Parameters
dest
all
message
Defaults
None.
Mode
Switch command, Read‐Write.
11-6 Network Monitoring Configuration
User
Location
rw
134.141.192.119
rw
134.141.192.18
Specifies the user to which this message will be sent. Valid syntax is
user@location.
Sends a broadcast message to all users.
Text message.
show users