Set Rmon Matrix Properties; Set Rmon Matrix Status - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring RMON
Table 11-7 show rmon matrix Output Details (continued)
Output...
Octets
Errors

set rmon matrix properties

Use this command to configure an RMON matrix entry.
Syntax
set rmon matrix properties index port-string [owner]
Parameters
index
port‐string
owner
Defaults
If owner is not specified, monitor will be applied.
Mode
Switch command, Read‐Write.
Example
This example shows how to configure RMON matrix entry 1 for fe.1.1
Matrix(rw)->set rmon matrix properties 1 fe.1.1

set rmon matrix status

Use this command to enable an RMON matrix entry.
Syntax
set rmon matrix status index enable
Parameters
index
enable
Defaults
None.
11-34 Network Monitoring Configuration
What it displays...
Number of octets (excluding framing bits, but including FCS octets)
contained in all packets transmitted from the source address to the
destination address.
Errors recorded.
Specifies an index number for this entry. An entry will automatically be
created if an unused index number is chosen. Maximum number of
entries is 2. Maximum value is 65535.
Specifies port(s) on which to monitors statistics.
(Optional) Specifies the name of the entity that configured this entry.
Specifies an index number for this entry. Maximum number of entries is
2. Maximum value is 65535.
Enables or disables this matrix entry.
set rmon matrix properties