Configuring Access Lists; Show Access-Lists; Purpose; Commands - Enterasys Matrix DFE-Gold Series Configuration Manual

show access-lists

Configuring Access Lists

Purpose

To review and configure security access control lists (ACLs), which permit or deny access to
routing interfaces based on protocol and source IP address restrictions.

Commands

For information about...
show access-lists
access-list (standard)
access-list (extended)
ip access-group
show access-lists
Use this command to display configured IP access lists when operating in router mode.
Syntax
show access-lists [number]
Parameters
access‐list‐
number
Defaults
If number is not specified, the entire table of access lists will be displayed.
Mode
Router command, Any router mode.
Example
This example shows how to display IP access list number 101. This is an extended access list,
which permits or denies ICMP, UDP and IP frames based on restrictions configured with the one
of the access‐list commands. For details on configuring standard access lists, refer to "ip access‐
group" on page
(extended)" on page 24‐17.
Matrix>Router#show access-lists 101
Extended IP access list 101
permit icmp host 18.2.32.130 any
permit udp host 198.92.32.130 host 171.68.225.126 eq
Router: These commands can be executed when the device is in router mode only. For details on
how to enable router configuration modes, refer to
page 2-103.
(Optional) Displays access list information for a specific access list
number. Valid values are between 1 and 199.
24‐20. For details on configuring extended access lists, refer to "access‐list
"Enabling Router Configuration
Enterasys Matrix DFE-Gold Series Configuration Guide 24-15
Configuring Access Lists
Modes" on
Refer to page...
24-15
24-16
24-17
24-20