Clear Radius Accounting - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring RADIUS
index | all
server ip_address port
server‐secret
Defaults
None.
Mode
Switch command, Read‐Write.
Examples
This example shows how to enable the RADIUS accounting client for authenticating with the
accounting server 1 at IP address 10.2.4.12, UDP authentication port 1800. As previously noted,
the "server secret" password entered here must match that already configured as the Read‐Write
(rw) password on the RADIUS accounting server
Matrix(rw)->set radius accounting server 1 10.2.4.12 1800:
Server Secret:******
Retype Server Secret:******
Make This Entry Active (y/n)? y
Warning: rfc2138 recommends secret minimum length of 16
This example shows how to set the RADIUS accounting timeout to 30 seconds on server 6:
Matrix(rw)->set radius accounting timeout 30 6
This example shows how to set RADIUS accounting retries to 10 on server 6:
Matrix(rw)->set radius accounting retries 10 6

clear radius accounting

Use this command to clear RADIUS accounting configuration settings.
Syntax
clear radius accounting {[server{index | all}] [retries {index | all}] [timeout
{index | all}] [intervalminimum] [updateinterval]}
Parameters
server index | all
retries index | all
timeout index | all
intervalminimum
updateinterval
25-58 Authentication Configuration
Applies the settings to a specific RADIUS accounting server or to all.
Specifies the accounting server's:
• IP address
• UDP authentication port (0 ‐ 65535)
• server‐secret (Read‐Write password to access this accounting server.
Device will prompt for this entry upon creating a server instance, as
shown in the example below.)
Clears the configuration on one or more accounting servers.
Resets the retries to the default value of 2 on one or more accounting
servers.
Resets the timeout to 5 seconds on one or more accounting servers.
Resets the minimum interval to 600 seconds.
Resets the update interval to 1800 seconds.
clear radius accounting