Show Spantree Spanguard; Set Spantree Spanguard - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Bridge Parameters

show spantree spanguard

Use this command to display the status of the Spanning Tree span guard function.
Syntax
show spantree spanguard
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the span guard function status:
Matrix(rw)->show spantree spanguard
spanguard is currently disabled.

set spantree spanguard

Use this command to enable or disable the Spanning Tree span guard function.
Syntax
set spantree spanguard {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
When enabled, this prevents an unauthorized bridge from becoming part of the active Spanning
Tree topology. It does this by disabling a port that receives a BPDU when that port has been
defined as an edge (user) port (as described in "set spantree adminedge" on page 6‐60). This port
will remain disabled until the amount of time defined by the set spantree spanguardtimeout ("set
spantree spanguardtimeout" on page 6‐38) has passed since the last seen BPDU or the port is
manually unlocked (as described in "clear / set spantree spanguardlock" on page 6‐39).
6-36 Spanning Tree Configuration
Enables or disables the span guard function.
show spantree spanguard